I realize that this will move the handwheel out, but it's not an issue. I know less than nothing about steppers, controllers, etc. Some type of controller to control speed and direction. This would be similar to the CNC conversion but minus the ball screw stuff, etc. a stepper motor between the crossfeed screw and the handwheel. The same type of windshield wiper motor that I used for the carriage feed with an H-bridge controller and variable pot.ī. A cogged belt drive with one pulley on the handwheel collar and the other on the motor shaft. The two possibilities that have occurred to me are.Ī. I want to be able to use the power crossfeed OR the handwheel without going through some major changeover procedure. This is NOT the first step in CNCing my lathe.ģ. There is no room at the rear of the carriage or underneath.Ģ. I have many questions and some parameters for you guys to follow.ġ. It seems as if, when I near the end of a build, I begin thinking about "what's next." I have 4 sets of plans on the bench, but, I would really like a power crossfeed for my lathe (Grizzly G0602 10x22.)Īfter I made the power carriage feed (independent of the spindle speed) I realized the improvement in surface finish was significant over hand cranking.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |